Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Pacific, WA
Most gate repairs in Pacific run $180 – $340 for opener work and $250 – $450 for a snapped hinge or leaning post before parts, and we can usually have a technician to your home the same day you call. Calder Gate Repair is the dedicated gate specialist inside the Relay Home Co. family, and we work on everything from a sagging driveway gate off Ellingson Road to a sliding opener that quit after a winter storm. Call (903) 417-0793 and a live person answers, 24/7.
Why Pacific Homes Are Different
Pacific sits right at the edge of the Green River valley, which means two things for gates: soft, damp soil and a lot of moisture in the air from October through April. Steel posts set in that soil shift more than they would up on a dry hillside, so we regularly see Pacific gates that drag on the latch side or bind at the hinge because the post has settled a half inch. The fix isn’t just beating the post back into place. It’s getting the load off the opener, realigning the hinge line, and often resetting the travel limits so the motor isn’t fighting a gate it was never designed to push.
Homes here skew newer than King County’s average, but plenty of original 1990s and early 2000s builds still run their first opener. Those units are at the age where capacitor failures and burned limit switches show up without warning. The good news is most of them are LiftMaster, FAAC, or Linear units that we keep parts for and know how to diagnose in one visit. A gate that won’t open here usually isn’t a mystery. It’s a wet control board, a corroded safety edge, or a post that finally lost its footing.
The other Pacific-specific factor is HOA and code compliance. Several communities east of Highway 167 have shared entrance gates and written rules about repair turnaround, gate finish, and even which opener brands are allowed as replacements. If your HOA has a spec sheet, we work to it and give you a written quote that matches what the board needs to see before approving the work.
Our Main Pacific Services
Most Pacific homeowners reach us for one of two reasons: a gate that won’t open or close, or an opener that’s making noise but not moving the gate. Each service below has its own Pacific page with pricing and details.
Gate Repair in Pacific
A gate that drags, sags, or won’t latch in Pacific usually comes down to one of three problems: posts that have settled in the valley’s wet soil, hinges that have worn oval, or a frame that’s racked from years of wind off the river. We rebuild hinge points, reset posts with proper base material so they stay put, and adjust the gate so it swings or slides without putting strain on the opener. The goal is a gate and opener working as one unit, not two things fighting each other. Gate Repair in Pacific covers full pricing, including what a leaning post repair runs on a typical Pacific lot.
Electric Gate Repair in Pacific
Pacific’s damp winters are hard on low-voltage systems. We see corroded wire nuts at the photo eyes, water inside the cabinet, and safety loops that short out after weeks of rain. This service covers the electrical side of the gate: diagnosing dead panels, replacing burned boards, rewiring photo eyes and loops, and getting the whole system talking again. Every repair includes the 365-Day Done Right Promise, so if the same fault returns within a year, the second visit is free. Electric Gate Repair in Pacific has line-item pricing and the brands we service most here.
Gate Opener Repair in Pacific
If the gate is physically fine but the motor hums, clicks, or does nothing, the opener is the problem. We stock boards, capacitors, limit switches, and receiver modules for LiftMaster, FAAC, BFT, Linear, Viking, and Mighty Mule units, which covers most openers installed in Pacific over the last 20 years. We diagnose the opener the same visit, give you a written price to fix or replace it, and never start work until you approve the number. Gate Opener Repair in Pacific breaks down common opener faults and what they cost to correct.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Pacific
Our technicians are factory-familiar with nine major opener brands, including the ones we see most in this part of King County: LiftMaster, FAAC, BFT, and Linear. We keep boards and common parts for those four on the truck, which means many Pacific opener repairs are finished same-day. For less common units, see our brands page for the full service list. If your opener isn’t listed, call anyway. A live person will tell you straight whether we can help before you book anything.
Pricing for Gate Company in Pacific, WA
| Service | Typical range in Pacific |
|---|---|
| Gate opener repair | $180 – $320 before parts |
| Electric gate diagnostic visit | $85 – $125 |
| Gate hinge repair (standard steel gate) | $250 – $450 |
| Leaning gate post reset | $400 – $700 |
| Limit switch replacement | $90 – $160 |
| Control board replacement | $200 – $400 before part cost |
| Safety sensor (photo eye) repair | $110 – $200 per side |
| Gate opener installation (basic swing) | $900 – $1,700 |
| Sliding gate opener installation | $1,400 – $2,500 |
| Intercom/keypad entry install | $400 – $900 |
| Loop detector replacement | $180 – $350 |
| Full gate replacement (standard driveway) | $1,800 – $4,500 |
What moves the price in Pacific is usually the gate itself. A heavy steel gate with a rusted post takes longer than a light aluminum one, and access matters too. If the gate is at the bottom of a sloped driveway with limited staging room, the job runs toward the higher end of the range. Whatever the number is, you get it in writing before we start, and that written price is the invoice price. No surprises at the door, no change orders you didn’t approve.
Neighborhoods We Serve in Pacific
We cover all of Pacific and the streets that feed into it from both sides of the valley. Typical response time for the area is same-day for most calls placed before early afternoon, with next-morning slots for everything else.
- Downtown Pacific near 3rd Avenue
- The neighborhoods east of Highway 167
- Ellingson Road corridor
- Areas near the White River
- The newer developments along the Milton edge
Service Area – Cities Near Pacific
Beyond Pacific proper, we regularly take calls from homeowners in Milton, WA and Federal Way, WA in the immediate area, plus Puyallup, WA to the south. We also keep a presence near the King County edge for neighbors in Auburn, CA who own property in both regions. If you live in a nearby community and need gate work, call (903) 417-0793 and we’ll confirm coverage before you book.
Serving Pacific, WA - Our Local Coverage Area
We’re based in the Pacific area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Pacific
Most Pacific calls placed before about 2 p.m. get a same-day visit. Every technician arrives with a live, trackable arrival time you can follow on your phone, not a four-hour window. Call (903) 417-0793 and a live person confirms your slot while you’re on the line.
Several communities in Pacific, especially east of 167, require written quotes before gate work starts and may specify opener brands or gate finishes. We write quotes that meet those requirements, and if your HOA needs a specific repair detail documented, we include it. Same-day service is usually fine, but we’ll flag any community rules before the work happens.
Yes. Every repair in Pacific carries the written guarantee: if the repair fails within 365 days, we return and make it right at no charge. The promise is printed on your invoice, and there’s no fine print or claim process. It’s a straightforward commitment, and it applies to every job we do in this city.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Pacific Customers Say
"Safety sensors realigned. Works fine. Photo eyes were dirty and out of line. Gate now stops when it should."
- Raul A."Booked online. The tech texted his ETA and arrived on time. Gate opener was dead; he replaced the control board and tested the sensors."
- Terry W."Booking was easy and the job was done quickly."
- Seth R.