Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Calabasas, CA
Calder Gate Repair is the dedicated gate company Calabasas homeowners call when a driveway gate stops opening, a keypad goes dark, or an opener grinds but won’t move. We work on gates across The Oaks, Mulholland Heights, Saratoga Hills, and the gated communities off Parkway Calabasas, and we know how this area’s iron, steel, and redwood gates hold up to sun, wind, and canyon dust. Every Calabasas job gets a written price before work starts, and every repair carries our 365-Day Done Right Promise. Call (903) 417-0793 any hour, and a live person answers.
Why Calabasas Homes Are Different
Calabasas gates face a specific set of conditions, and they change how we diagnose and repair them. The summer heat off the Santa Monica Mountains bakes opener circuit boards and dries out the grease in swing-arm operators faster than coastal neighborhoods. Santa Ana winds push dust and fine grit into tracks, hinges, and gear housings, which accelerates wear on steel gates along Mulholland Drive and in the hill sections. We also see a lot of long, sloping driveways in Calabasas, where a gate that cycles slowly or reverses halfway creates a real traffic problem for the homeowner.
Housing here runs from 1980s and 1990s estates in The Oaks and guard-gated communities to newer builds in neighborhoods like Gated Calabasas Park and the custom homes off Cold Canyon Road. That means we’re often matching replacement parts to openers that have been out of production for years, and we stock the common boards, arms, and sensors for older DoorKing, Elite, and Viking units specifically because Calabasas homes have a lot of them. HOAs in the area, particularly in the gated enclaves along Parkway Calabasas, often require uniform gate heights and matched hardware, so we’re careful to source visible components that keep the whole entrance consistent.
Our Main Calabasas Services
The two calls we take most often from Calabasas are a gate that won’t open at all and an opener that runs but won’t move the gate. Here’s what each one involves, with a dedicated page for the details:
Gate Repair in Calabasas
Gate repair here means the physical gate itself: sagging hinges, misaligned posts, bent rails, cracked welds, a gate that drags on the driveway, or a panel that’s shifted out of square. In Calabasas, we see a lot of steel gates that have warped slightly in the valley heat and gates on slopes where the post has settled. We realign, weld, and replace hardware, and we match the finish so the repair doesn’t stand out. Full pricing and what a same-day visit covers live on the Gate Repair in Calabasas page.
Electric Gate Repair in Calabasas
Electric gate repair covers the parts that make a manual gate automatic: the motor arm, the power feed, safety sensors, photo eyes, and the wiring between them. Calabasas electric gates running along unshaded driveways bake in the afternoon heat, and we regularly replace scorched motor capacitors and sun-degraded sensor lenses in the hill neighborhoods. Every repair carries the 365-Day Done Right Promise, and the written price always covers labor and parts up front. See the full breakdown on our Electric Gate Repair in Calabasas page.
Gate Opener Repair in Calabasas
Gate opener repair is about the operator itself: the circuit board, remote receivers, limit switches (the small sensors that tell the gate when to stop), keypads, and remotes. Calabasas homeowners often have openers that fail intermittently on hot afternoons or after a wind storm, and we carry replacement boards and receivers for the brands common up here, including Ghost Controls, Viking, and Elite. A failing opener isn’t just an inconvenience, it can leave your driveway exposed and your family locked out or in. The Gate Opener Repair in Calabasas page covers typical opener faults and the cost to set them right.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Calabasas
We service all nine major opener brands, and on Calabasas routes we stock parts for Viking, Ghost Controls, DoorKing, and Elite because those are the names we see most on local gates. Same-day board swaps are common when the part is already on the truck. See our brands for the full list and how we test each unit.
Pricing for Gate Company in Calabasas, CA
Every job is quoted in writing before we touch a bolt, and the number on the invoice is the number we agreed to. Here are the ranges Calabasas homeowners can expect for common gate work:
| Service | Typical range in Calabasas |
|---|---|
| Gate roller replacement | $180 – $320 |
| Hinge replacement or weld repair | $220 – $450 |
| Gate sag realignment | $200 – $400 |
| Circuit board replacement | $280 – $520 |
| Remote, receiver, or keypad replacement | $150 – $300 |
| Limit switch replacement | $160 – $280 |
| Gear or chain drive repair | $260 – $500 |
| Electric strike or magnetic lock repair | $240 – $460 |
| Full opener motor swap | $550 – $1,050 |
Prices in Calabasas run toward the middle of these ranges when the gate is a standard swing or slide model with easy driveway access. Long, steep driveways in the hills, HOA-matched finishes, and older openers that need obsolete parts are what push a quote toward the top. Whatever the number, it’s written down and agreed to before work begins, never a surprise on the invoice.
Neighborhoods We Serve in Calabasas
We cover the whole Calabasas area, from the gated enclaves to the canyon roads. Our Calabasas response is typically same-day for repair calls placed before early afternoon, since our technicians are already moving through the area throughout the week.
- The Oaks
- Mulholland Heights
- Saratoga Hills
- Calabasas Park
- Cold Canyon
Service Area – Cities Near Calabasas
We also run gate repair calls just outside Calabasas, through Topanga, CA, Agoura Hills, CA, Oak Park, CA, and Westlake Village, CA. Scheduling for Calabasas is coordinated from our Los Angeles dispatch office, and our crews serve the area locally every day.
Serving Calabasas, CA - Our Local Coverage Area
We’re based in the Calabasas area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Calabasas
Most Calabasas repair calls placed before early afternoon get a same-day visit. We dispatch technicians live with a trackable arrival time, so you’ll know exactly when we pull up, not a four-hour window.
Some do, particularly in gated communities where gate height and hardware style are uniform. If your HOA has a spec sheet, we’ll match the visible components to it, and we’re happy to wait for board approval before we start.
Yes. Every Calabasas job gets a written quote first, covering labor and parts, and the invoice at the end matches that number. If a repair fails within 365 days, we return free of charge under the 365-Day Done Right Promise.
For same-day gate repair in Calabasas, call Calder Gate Repair at (903) 417-0793. A live person answers 24/7, the estimate is free, and the price you approve is the price you pay.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Calabasas Customers Say
"Good job on the motor. Part took a few days to arrive, but the updates came by text."
- Oscar J."Safety sensors realigned. Works fine. Photo eyes were dirty and out of line. Gate now stops when it should."
- Raul A."Booked online. The tech texted his ETA and arrived on time. Gate opener was dead; he replaced the control board and tested the sensors."
- Terry W.