Electric Gate Repair in Mukilteo - On-Site in 60 Minutes, Fixed the Same Day

Fast, Reliable Electric Gate Repair Across Mukilteo

Electric gate repair in Mukilteo usually comes down to one of three things: a motor fighting a slope it wasn’t sized for, a control board shorted by marine air, or a post that’s shifted and thrown the whole gate out of alignment. Our Electric Gate Repair techs fix all three every week, from Harbour Pointe to the hillsides above the ferry dock. If your gate is stalling, beeping, or refusing to open, call Calder Gate Repair at (903) 417-0793. We answer live, we give you a real arrival time, and the price is in writing before we turn a single bolt.

Call (903) 417-0793

Why Calder Gate Repair Is Mukilteo’s Preferred Electric Gate Repair Company

We know Mukilteo gates because we work on them constantly. The salt air off Possession Sound does things to steel hinges and control boards that an inland gate simply never sees, and the sloped lots along the waterfront demand operator sizing that a flat-lot spec doesn’t cover. Nico Alvarez runs our crew, and he’s built Calder Gate Repair inside the Relay Home Co. family around one principle: diagnose the real fault, name the price, and stand behind the fix.

Every Calder job in Mukilteo carries the 365-Day Done Right Promise in writing. If your repair fails within a year, we come back free. Every ticket starts with a written quote before work begins, and our techs are background-checked, uniformed, and dispatched with a live arrival time you can track on your phone. Call the office any hour and a live person answers, not a voicemail.

Electric Gate Motor in Mukilteo

Electric gate motor repair in Mukilteo is our most common call, and on waterfront hillside properties it’s often a misdiagnosis waiting to happen. A motor that stalls halfway or trips its breaker may be perfectly fine while the real fault sits at the hinge post or in the capacitor. Our techs bench-test the motor, check amp draw under load, and inspect the post footing and panel alignment before condemning anything. Most motor repairs in Mukilteo run $220 to $480 before parts, including the diagnostic time.

When the Operator Isn’t the Problem

On sloped driveways, a shifted post or a sagging hinge transfers weight into the operator, so it over-amps and shuts down mid-travel. A flat-land tech might swap the motor and paper over it for a few months. We check the geometry first.

Capacitor and Limit Switch Work

Many “dead motors” are a $25 capacitor. When limit switches drift, gates stop short or bang past the stop. We reset, retest, and set the full travel arc so the operator isn’t fighting itself.

Gate Access Control in Mukilteo

Gate access control in Mukilteo covers keypads, remotes, loop detectors, telephone entry systems, and the low-voltage wiring that runs everything at the gate. If your keypad works intermittently or the gate opens when it shouldn’t, the fault is usually in the control wiring or a corroded terminal strip, not the keypad itself. Most keypad and access control repairs run $140 to $310, with board-level repairs landing higher if the corrosion has spread.

Keypads and Corrosion

Sound-facing keypads pit fast. We replace keypads with sealed units and treat the terminals so the new one doesn’t die in a year. If the keypad is wired into a loop detector, we check the loop tuning at the same time.

Loop Detectors and Safety Edges

A loop detector out of tune can hold the gate open, refuse to close, or open randomly. Safety edges that don’t reverse the gate are a serious problem. We test every edge and photocell after every access control repair. No exceptions.

Trusted Brands We Service in Mukilteo

We carry control boards, remotes, capacitors, and safety parts for FAAC, Linear, and Viking operators, among others, and we keep common repair parts stocked for the Mukilteo fleet. If your gate has a FAAC hydraulic operator, a Linear slide unit, or a Viking swing setup, we can usually diagnose and quote the repair on the first visit.

Common Electric Gate Repair Problems We See in Mukilteo Homes

• Slider gates stalling on sloped approaches. The operator gets blamed, but the real fault is often a shifted post footing or a bind in the hinge post. The motor over-amps and trips out mid-travel.
• Marine-air corrosion on the Sound-facing side. Keypad buttons, safety photocells, and control-box terminals pit and short far earlier than inland Snohomish County gates a few miles east.
• Gate opens on its own, or won’t close. Usually a loop detector out of tune or a photocell blinded by glare off the Sound. Both are reproducible on site.
• Gate slams past the stop or stops two feet short. Limit switch drift. Easy to reset on older operators, but newer boards sometimes need a replacement module.

Pricing for Electric Gate Repair in Mukilteo, WA

We Also Serve Cities Near Mukilteo

Calder Gate Repair handles electric gate work across Mukilteo and up and down the Sound: Mill Creek, Everett, Lynnwood, and Edmonds. If you’re just outside Mukilteo, call us. Our crews are scheduled out of the Seattle office, so an Everett or Lynnwood stop usually slots in the same day as a Mukilteo call.

FAQs About Electric Gate Repair in Mukilteo