Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Everett, WA
If you’re searching for a gate company in Everett, WA, you’re likely dealing with a gate that won’t open, won’t close, or makes a sound like a garbage disposal full of forks. Calder Gate Repair is the dedicated gate repair specialist inside the Relay Home Co. family, and we operate differently than the average garage door shop that also “does gates.” Everett’s mix of steep lots, salty marine air off Possession Sound, and older hillside homes means gate hardware corrodes faster and shifts more than it does inland. We quote a written price before any work starts, and a live person answers our phone 24/7 at (903) 417-0793.
Why Everett Homes Are Different
Everett’s geography shapes how gates fail. The city climbs from the waterfront up through Riverside, Port Gardner, and View Ridge into the Cascade foothills, which means a lot of driveways sit on a noticeable slope. Gravity never stops working: a gate that’s even a few degrees out of level will bind at the latch, wear out hinges faster, and make the opener motor strain until it burns out. We see this constantly in neighborhoods like Boulevard Bluffs and Glacier View, where the terrain is beautiful but unforgiving to gate hardware.
The marine influence matters too. Homes near the Mukilteo line, the waterfront, and anything within a mile or two of the sound get a steady diet of salt-laden moisture. Exposed steel rusts, circuit boards corrode, and grounding connections degrade faster than they do ten miles east. That’s why we stock replacement control boards, photo eyes, and limit switches locally so we’re not waiting on a warehouse in another state when a gate opener repair in Everett needs to happen same-week. Older homes in Northwest Everett and the historic Rucker Hill area often have wider, heavier gates built from wood and steel tube, which puts extra demand on the opener. A unit sized for a lightweight builder-grade gate will fail years early under that load.
Our Main Everett Services
Three services account for nearly every call we take in Everett. Each has its own page, but here’s the short version of what each one involves and why the local conditions matter.
Gate Repair in Everett
Most gate repair in Everett calls start as “the gate is stuck” or “it’s making a grinding noise.” Once we’re on site, the culprit is usually a combination of rusted hinges, a gate that’s shifted out of square, or a broken weld on the frame. Older Everett properties with hand-built steel gates tend to fail at the joint between the frame and the hinge posts first. We cut and re-weld on site, re-hang the gate, and leave it swinging smoothly under its own weight. Every gate repair includes the 365-Day Done Right Promise in writing: if the same repair fails within a year, we return at no charge.
Electric Gate Repair in Everett
Electric gate repair in Everett usually means troubleshooting somewhere between the breaker panel, the control board, and the motor. In our coastal climate, corroded terminals on the low-voltage wiring are the most common culprit, especially where sprinklers or landscape lighting share a conduit. We carry replacement transformers, receivers, and keypads on the truck, so most electric gate jobs wrap up in a single visit. One local quirk: properties in unincorporated areas just outside city limits sometimes have 30-year-old openers with capacitors that are no longer manufactured, and we’ll explain your replacement options before proposing a single dollar.
Gate Opener Repair in Everett
When the motor runs but the gate doesn’t move, or the remote stopped working overnight, you need gate opener repair in Everett. The brands we see most in Snohomish County are Linear, Viking, Ghost Controls, and DoorKing, and we’re factory-familiar with each of them. Hillier neighborhoods like View Ridge see premature gear wear because the opener works against gravity on every cycle. We diagnose the limit switch, the gearbox, and the control board in sequence to avoid replacing parts that are still good. Then you get a written price before anything gets swapped out.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Everett
The driveways around Everett carry a mix of operator brands depending on when the gate went in. We service Linear, Viking, Ghost Controls, and DoorKing as a matter of routine, and we keep boards, remotes, and gear kits for each in local stock. That means most opener jobs don’t wait on shipping. For a fuller picture of what we work on, our brands page covers the full lineup.
Pricing for Gate Company in Everett, WA
| Service | Typical range in Everett |
|---|---|
| Diagnostic visit | $75 – $125 |
| Gate not opening or closing | $150 – $350 |
| Electric gate lost power or trips breaker | $175 – $400 |
| Gate opener motor replacement | $350 – $850 |
| Circuit board replacement | $200 – $475 |
| Photo eye sensor repair | $95 – $220 |
| Remote or keypad not working | $80 – $175 |
| Hinge or wheel replacement | $140 – $325 |
| Gate frame welding repair | $150 – $450 |
| Full service and tune-up | $189 – $349 |
Prices in Everett run slightly higher on hillside properties where we need to re-level a shifted gate, and on rusted hardware that requires cutting bolts rather than turning them. Whatever the number, you’ll see it in writing before the first tool comes out. The invoice never exceeds the quote.
Neighborhoods We Serve in Everett
We take calls across the whole city and most of the surrounding Snohomish County area. Most days, we can reach an Everett address within about 60 to 90 minutes once a job is booked, and you can track the tech’s arrival time live instead of waiting through a four-hour window.
- Rucker Hill and Northwest Everett
- View Ridge and Forest Park
- Riverside and Port Gardner
- Boulevard Bluffs and Glacier View
- Silver Lake and the Mukilteo border area
Service Area – Cities Near Everett
Beyond Everett city limits, our crews regularly handle calls in the surrounding cities. If you’re nearby and need the same written-price, 365-day-guarantee approach, take a look at our pages for Marysville, WA, Lake Stevens, WA, Mukilteo, WA, and Snohomish, WA. Same live-answer phone, same background-checked techs.
Serving Everett, WA - Our Local Coverage Area
We’re based in the Everett area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Everett
Most Everett jobs get a same-day or next-day visit, and once the truck is dispatched you’ll see a live arrival time you can track. Call (903) 417-0793 and the person who answers is a live human who can book you immediately, day or night.
Not for repairs. HOAs in gated Everett communities generally only require approval for changes in appearance, like a different gate color or style. Same-material, same-color repairs are treated as maintenance. If your HOA does have a form, we can provide the written quote they usually ask for.
We serve the entire city of Everett plus Marysville, Lake Stevens, Mukilteo, and Snohomish. If your driveway gate is acting up and you want a written price before anyone turns a wrench, call (903) 417-0793 for a free estimate.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Everett Customers Say
"Keypad and remotes reprogrammed in one visit. Paid by link."
- Pauline C."Good job on the motor. Part took a few days to arrive, but the updates came by text."
- Oscar J."Safety sensors realigned. Works fine. Photo eyes were dirty and out of line. Gate now stops when it should."
- Raul A.