Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Redmond, WA
Calder Gate Repair is the dedicated gate specialist inside the Relay Home Co. family, handling gate repair, electric gate repair, and gate opener repair across Redmond, WA. Most Redmond jobs come down to one thing: a gate that worked fine through the dry summer starts binding, grinding, or refusing to move once the rainy season hits. If your gate is stuck halfway, beeping without moving, or sagging off its hinges, call (903) 417-0793 and we’ll give you a written price before any work starts.
Why Redmond Homes Are Different
Redmond’s mix of 1980s and 1990s ramblers, early-2000s buildouts along Education Hill, and newer construction north of Novelty Hill Road means we see three very different gate generations in one service area. The older steel tube gates on Education Hill and around Idylwood are prone to hinge wear and sag. The aluminum driveway gates common in Redmond Ridge and Trilogy deal with a different issue: opener electronics that get fussy with temperature swings.
Wet winters are the biggest factor here. Redmond gets more rain than Seattle on average, and that moisture works on every moving part. We regularly replace rusted gate hardware in the Viewpoint and Grass Lawn neighborhoods after a few wet seasons. Limit switches, the small sensors that tell the gate when to stop, corrode faster here than in drier parts of King County. If your gate hesitates or reverses for no reason in late fall, that’s often the culprit.
Our Main Redmond Services
These are the three services Redmond homeowners call us about most, and each has its own detailed page with pricing and specifics.
Gate Repair in Redmond
This covers the physical gate itself: sagging frames, broken hinges, bent posts, misaligned pickets, and gates that drag on the driveway. In Redmond, the most common physical failure we see is a gate that was installed before the frost-depth and drainage patterns here were fully understood, leaving posts to shift over time. Gate Repair in Redmond covers everything from a single hinge replacement to a full gate rebuild.
Electric Gate Repair in Redmond
Electric gates in Redmond run on a mix of control boards, safety loops, keypads, and wiring runs, all of which take a beating in our wet climate. Ground loops, the buried sensors that detect a car and keep the gate from closing on it, are especially vulnerable here. When moisture gets into a wire splice or a loop connection, the gate starts behaving erratically. Electric Gate Repair in Redmond walks through the full diagnosis and fix.
Gate Opener Repair in Redmond
The opener, the motor and gearbox that actually swings or slides the gate, fails in predictable ways. We see stripped gears on older chain-drive openers, burned control boards, and remotes that stop syncing. Redmond’s temperature swings between cold snaps and warm days can stress solder joints on control boards over time. Gate Opener Repair in Redmond covers every major brand we service, from first diagnosis to final test.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Redmond
We’re factory-familiar with nine major gate opener brands, including FAAC, BFT, Linear, and Viking, which covers most of what’s installed across Redmond. Our trucks carry common boards, remotes, and safety-edge parts for these brands, so many Redmond repairs finish in a single visit. See our brands for the full list.
Pricing for Gate Company in Redmond, WA
| Service | Typical range in Redmond |
|---|---|
| Gate opener repair (labor only) | $180 – $340 |
| Electric gate diagnosis | $95 – $150 |
| Hinge replacement (pair) | $220 – $450 |
| Gate realignment and sag correction | $240 – $480 |
| Control board replacement | $300 – $600 |
| Safety sensor replacement | $145 – $260 |
| Remote and keypad programming | $90 – $180 |
| Chain or belt replacement | $190 – $320 |
| Post replacement (single) | $300 – $700 |
What pushes a Redmond quote toward the higher end is usually age and moisture. A corroded post base on an Education Hill gate that’s been in the ground since 1998 takes more labor than a simple hinge swap on a newer Redmond Ridge install. Every Redmond job gets a written price before we start, and that number doesn’t change at the door.
Neighborhoods We Serve in Redmond
We run routes across Redmond daily. Most calls in the following neighborhoods get a same-day or next-day arrival window, depending on when you call and what the gate is doing:
- Education Hill
- Downtown Redmond
- Grass Lawn
- Idylwood
- Redmond Ridge
- Viewpoint
Service Area – Cities Near Redmond
Our Redmond crews also cover the surrounding Eastside communities. If your gate is in Kirkland, WA, Sammamish, WA, Bellevue, WA, or Woodinville, WA, the same written-price guarantee and 365-Day Done Right Promise apply. Dispatch and scheduling are coordinated from the brand’s Seattle office, with crews serving Redmond locally.
Serving Redmond, WA - Our Local Coverage Area
We’re based in the Redmond area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Redmond
Most Redmond calls get a same-day or next-day arrival, and every arrival time you get is live and trackable. If your gate is stuck open and your property is unsecured, tell the person on the phone and we’ll prioritize it. Call (903) 417-0793 and you’ll reach a live person any hour, any day.
Many Redmond communities with shared gates, like Redmond Ridge and Trilogy, require HOA sign-off before major gate or opener work starts. A repair that restores the existing gate to working order is usually fine, but we’ll tell you if your job looks like it crosses into replacement territory. We can provide written descriptions for HOA review.
First, check if the breaker or GFCI tripped, which is common in Redmond’s wet months. If resetting doesn’t fix it, don’t force the gate manually because you can damage the opener gears. Call us and we’ll diagnose it, and with the 365-Day Done Right Promise, if our first repair doesn’t hold, we return at no charge.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Redmond Customers Say
"Booked online. The tech texted his ETA and arrived on time. Gate opener was dead; he replaced the control board and tested the sensors."
- Terry W."Booking was easy and the job was done quickly."
- Seth R."Swing gate arm replaced and aligned. Got photos of the old part by text."
- Nadia F.