Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Northlake, TX
Calder Gate Repair is the gate company Northlake homeowners call when a gate stops opening, starts grinding, or refuses to close all the way. Most gate opener repairs in Northlake run between $180 and $390 before parts, and we diagnose the issue on site with a written price before any work begins. Northlake’s mix of acreage properties and newer subdivisions means we see everything from long driveway swing gates to compact lift-master slide operators. Call (903) 417-0793 and a live person answers, 24 hours a day.
Why Northlake Homes Are Different
Northlake sits at the intersection of rural-space living and fast DFW growth, and that shows up in the gate work we do. Properties along Cleveland Gibbs Road and Harvest Way tend to have longer driveway runs and heavier custom gates, often paired with openers that have been working hard in full Texas sun for years. Newer builds near Pecan Square and The Ridge at Northlake frequently ship with builder-grade operator arms that wear out within a few years of daily use.
Clay-heavy soil is the quiet factor here. Northlake ground shifts with wet and dry cycles, and gate posts set in that soil can drift a few degrees over time. That misalignment puts stress on hinges, opener arms, and limit switches, the small sensors that tell the gate when to stop. A gate that worked fine in May might bind in August, and a repair that only replaces the opener without addressing the post alignment will fail again. We account for that on every Northlake service call, because we see it on nearly every one of them.
Our Main Northlake Services
The two calls we get most from Northlake are gates that move but don’t work right, and openers that have died completely. Each service below has its own Northlake page with full pricing and troubleshooting detail.
Gate Repair in Northlake
A sagging gate on an acreage lot off Highway 114 is a different job than a tight-fitting gate in a Harvest neighborhood alley. We handle both. Our techs carry a full-shop inventory of hinges, casters, weld-on plates, and slide hardware to do most Gate Repair in Northlake on the first visit, and we’re factory-familiar with Linear and Viking operator systems that power a lot of these properties.
Electric Gate Repair in Northlake
When a gate starts stopping halfway, beeping, or reversing for no reason, the electrical side is where we look first. Northlake’s long driveway runs mean low-voltage wire gets buried across lawns and under flower beds, and a nicked line can cause intermittent failures that are easy to misdiagnose if you don’t test the whole path. We do. Our Electric Gate Repair in Northlake service includes full circuit checks, board diagnostics, and same-trip fixes whenever parts allow.
Gate Opener Repair in Northlake
Builder-grade openers fail on a schedule, and many Northlake homes are hitting that schedule right now. If your opener hums but doesn’t move, or moves but won’t stop, the fix is usually a gear kit, a capacitor, or a limit switch, the small sensor that tells the gate where to stop. We carry those parts for Ghost Controls and DoorKing units on the truck and can often complete Gate Opener Repair in Northlake on the first trip.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Northlake
We work on all major gate opener brands, and we stock local parts for Linear, Viking, Ghost Controls, and DoorKing units, which power a large share of Northlake gates. Most repairs are finished same-day or next-day. See our brands for the full lineup.
Pricing for Gate Company in Northlake, TX
| Service | Typical range in Northlake |
|---|---|
| Gate opener diagnostic | $80 – $130 |
| Limit switch replacement | $180 – $280 |
| Gate opener repair (major) | $280 – $450 |
| Gate opener replacement | $650 – $1,400 |
| Control board replacement | $380 – $680 |
| Safety sensor replacement | $160 – $260 |
| Hinge repair (double gate) | $250 – $500 |
| Slide gate roller replacement | $200 – $400 |
| Gate track realignment | $225 – $375 |
| Welded gate frame repair | $350 – $750 |
What pushes a Northlake price toward the top of these ranges is usually the gate itself, a heavy custom iron gate with a long travel distance takes longer to work on and wears parts faster. What doesn’t push it up is surprise billing. Calder Gate Repair gives every Northlake homeowner a written price before any work starts, and the number on the invoice matches the number agreed at the door.
Neighborhoods We Serve in Northlake
Our techs are on Northlake roads daily, from Harvest and Pecan Square to the acreage lots along Cleveland Gibbs Road and the newer developments near The Ridge at Northlake. We also cover the communities between 35W and the Denton County line. Typical response time across Northlake is 60 to 90 minutes for urgent repair calls.
- Harvest
- Pecan Square
- The Ridge at Northlake
- Cleveland Gibbs Road area
- Acreage properties off Highway 114
Service Area – Cities Near Northlake
Northlake is home base for our Denton County calls, but we regularly cross into surrounding metro areas for larger jobs and repeat customers. Our service area includes Fort Worth, TX, Dallas, TX, and points beyond, including Houston, TX and San Antonio, FL for customers who move or own multiple properties. If your gate is anywhere near a city on that list, call and ask.
Serving Northlake, TX - Our Local Coverage Area
We’re based in the Northlake area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Northlake
Most urgent Northlake calls get a tech on site within 60 to 90 minutes, depending on where you are in the service area and current call volume. Every call goes to a live person who can give you a trackable arrival time, never a voicemail. Call (903) 417-0793 day or night.
Some Northlake HOAs, especially in Harvest and Pecan Square, have rules about gate appearance, color, and materials. Repairs that keep the existing gate in place usually don’t require approval. Replacements or anything visible from the street may. We’ve worked within these communities and can flag the likely requirements before you start.
We cover the full Northlake area, including acreage properties off Highway 114 and every subdivision between I-35W and the Denton County line. There’s no trip charge for standard service calls within Northlake when work is completed. Call (903) 417-0793 to confirm your address and get a free estimate.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Northlake Customers Say
"Swing gate arm replaced and aligned. Got photos of the old part by text."
- Nadia F."Quote came in the app before the visit. No surprise at the end."
- Ginny L."Keypad and remotes reprogrammed in one visit. Paid by link."
- Pauline C.