Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Addison, TX
Gate repair in Addison, TX covers a lot more than a gate that won’t open. From swing gates on older Addison tree-lined streets to slide gates on larger properties in developments along Belt Line Road, the equipment takes a real beating from North Texas heat, sudden downpours, and clay soil that shifts with every dry spell. Most Addison gate calls we handle come down to opener failure, hinge or wheel wear, or a control board that quit after a storm. Call Calder Gate Repair at (903) 417-0793 and a live person answers, any hour.
Why Addison Homes Are Different
Addison sits on Dallas County clay that expands when wet and contracts hard during summer droughts. That movement transfers straight into gate posts and hinges. A gate that swung clean in March can drag or bind by August, and a post that shifted half an inch is often enough to throw off the opener’s limit switch – the small sensor that tells the gate when to stop. Homes along Arapaho Road and in the neighborhoods around Addison Circle also contend with storm runoff. After a heavy North Texas downpour, low spots near the gate track or operator box can hold water, and moisture inside a control board is one of the most common failures we see in this area.
Many Addison HOAs expect gates to match the original aesthetic and operate quietly, which means repairs usually favor replacement parts built for the existing opener rather than a generic swap. That’s a good thing: it keeps the job clean and the gate looking like it belongs. Add in summer surface temperatures that easily top 130 degrees on a metal gate, and you understand why the plastic gears, capacitors, and circuit boards fail here a little sooner than they do in milder climates.
Our Main Addison Services
The two calls we take most often from Addison are for gate openers that stopped working and gates that are off their track or sagging at the hinge. Here’s what each job actually involves in Addison.
Gate Repair in Addison
This usually means a gate that drags, sticks, leans, or won’t latch. In Addison we see a steady share of sagging iron gates on older properties where the original welded hinges have finally loosened, and slide gates where debris in the V-track along the drive has caused a wheel to bind. We cut off old hardware, set the gate square, and install new hinges, wheels, or brackets as needed. Most Addison repairs of this type are done in one visit with the new parts already on the truck. See the full breakdown on our Gate Repair in Addison page.
Electric Gate Repair in Addison
When the motor hums but the gate doesn’t move, or the gate opens but won’t close without help, the issue is usually electrical or mechanical inside the operator. Addison’s hard clay shifts and storms mean we check the capacitor, the control board, the transformer, and the wiring connections at the arm before quoting anything. We carry replacement boards and remotes for the brands most Addison homes already own, so the job often wraps up the same day. See our full service detail here: Electric Gate Repair in Addison.
Gate Opener Repair in Addison
A gate opener that ignores the remote, opens halfway, or trips the breaker every time it runs has a diagnosable problem, not a curse. In Addison we find failed limit switches, stripped drive gears, damaged receiver modules, and burned-out transformers as the usual culprits. Because we’re factory familiar with LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, we don’t burn an hour guessing. The full diagnostic and repair process is detailed on the Gate Opener Repair in Addison page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Addison
We’re trained across the nine major opener brands homeowners actually have, so when an Addison gate calls it quits we’re usually looking at a familiar control board, not a mystery box. Viking, Ghost Controls, DoorKing, and Elite are among the brands we stock parts for locally. That means less waiting on shipments and fewer repeat trips. For a full breakdown of models we cover, see our brands.
Pricing for Gate Company in Addison, TX
| Service | Typical Range in Addison |
|---|---|
| Diagnostic visit (applied to repair) | $49 – $79 |
| Gate opener motor replacement | $325 – $650 |
| Control board replacement | $180 – $420 |
| Limit switch replacement | $120 – $260 |
| Remote or keypad programming | $60 – $140 |
| Hinge replacement (pair) | $180 – $380 |
| Gate wheel and bracket replacement | $150 – $320 |
| Full gate opener installation | $850 – $1,700 |
| Photo eye or safety sensor replacement | $130 – $280 |
What pushes the final number up in Addison is usually rust or metal fatigue on older iron gates, or an opener that’s been left unserviced long enough that the problem spread from one part to two or three. The number on the invoice is the number we agreed to before a single bolt was turned – that’s the Relay Standard, and it’s not optional.
Neighborhoods We Serve in Addison
We cover all of Addison, from the condo and townhome communities near Addison Circle to the established single-family streets west of the Tollway and the neighborhoods closer to Belt Line Road. Our techs come from the Dallas-Fort Worth dispatch network and are on site in Addison fast – most jobs are handled same-day or next-day.
- Addison Circle
- Bent Tree
- Prestonwood
- Midway Meadows
- Les Lacs
Service Area – Cities Near Addison
Beyond Addison, we keep the same promises in the neighboring cities. Homeowners in Carrollton, TX, Richardson, TX, Coppell, TX, and Plano, TX get the same live-person phone answer, background-checked tech, written price before work starts, and the 365-Day Done Right Promise on every repair.
Serving Addison, TX - Our Local Coverage Area
We’re based in the Addison area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Addison
Most Addison calls are scheduled same-day or next-day, and our dispatch network out of Dallas-Fort Worth means a trackable arrival time, not a wait window. You’ll get a live person on the phone at (903) 417-0793 who can confirm a time and put you on the schedule right then.
Most repairs – hinges, openers, boards, wheels – don’t require a permit in Addison. A full replacement or a new gate post footing may, and we’ll flag that before any work is quoted so you’re not caught off guard. The written price we give covers the work, and any permit requirements are stated plainly before you approve anything.
Yes, and it’s usually simpler than people expect. We quote against parts and hardware that match the gate you already have, so aesthetic standards stay intact and the repair doesn’t trigger an HOA review. If your HOA has a specific approved-parts list, send it our way when you book, and we’ll build the quote around it from the start.
If your Addison gate is dragging, dead, or haunting you at 6 a.m., call Calder Gate Repair at (903) 417-0793. A real person answers, the price goes in writing before any work begins, and the 365-Day Done Right Promise backs every repair.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Addison Customers Say
"Keypad and remotes reprogrammed in one visit. Paid by link."
- Pauline C."Good job on the motor. Part took a few days to arrive, but the updates came by text."
- Oscar J."Safety sensors realigned. Works fine. Photo eyes were dirty and out of line. Gate now stops when it should."
- Raul A.