Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Baytown, TX
Calder Gate Repair is the gate company Baytown homeowners call when a driveway gate won’t open, won’t close, or starts grinding at 6 a.m. Most Baytown calls involve swing or slide gates on larger residential lots, and many sit on soils that shift with the seasons, which throws off gate alignment faster than people expect. We’re part of the Relay Home Co. family, founded in 2009, and we run every job on a written price agreed before work starts. Call (903) 417-0793 and a live person picks up, day or night.
Why Baytown Homes Are Different
Baytown sits low and flat, close to the water, and that shapes gate work more than most people realize. Humidity off Galveston Bay accelerates rust on hinges, posts, and opener housings, especially within a few miles of the water. Coastal clay soils also expand and contract through wet and dry cycles, which gradually knocks gate posts out of plumb. A gate that scraped the latch last summer may hang an inch low by spring, and that misalignment is exactly what burns out motors and strips drive gears.
Housing stock runs the full range here: older ranches near Lee Drive and Bayway Drive, mid-century neighborhoods around Goose Creek, and newer gated-style communities off Garth Road and north of I-10. Many homes on larger lots have double-swing driveway gates, while townhome and patio-home communities lean on slide gates with operator posts. Permits aren’t usually required for a repair on an existing gate, but any HOA with a shared entry gate may have its own access and scheduling rules. We work around them daily.
Our Main Baytown Services
Most Baytown calls boil down to two situations: a gate that physically won’t move correctly, or an opener that won’t do its job. Each has its own page below with local pricing and detail.
Gate Repair in Baytown
A sagging gate, a broken hinge, a caster that snapped, or a post that’s leaning out of line – that’s Gate Repair in Baytown. Here, the usual culprits are rust from bay humidity and soil movement under the posts. We realign the leaf, replace worn hardware, and re-set posts when needed, then run the gate through full cycles so the opener isn’t fighting the load. You get a written price before any bolt is touched, and the repair is covered by our 365-Day Done Right Promise.
Electric Gate Repair in Baytown
When the motor hums but nothing moves, or the gate stops halfway and reverses, that’s Electric Gate Repair in Baytown. Coastal moisture gets into control boards and limit switches faster here than inland, and low-voltage wiring connections corrode. We diagnose the full circuit – board, transformer, wiring, safety edges – then quote the repair in writing before starting. If it fails within a year, Calder returns at no charge. That guarantee is in writing on every electric gate job.
Gate Opener Repair in Baytown
If the opener’s keypad is dead, the remote stopped working, or the arm is making a sound like a coffee grinder, see Gate Opener Repair in Baytown. We service the brands Baytown homes actually have, including Linear, Viking, and Ghost Controls, and we stock common boards, remotes, and arms locally. The fix often takes under two hours. You’ll know the price before we start, and you’ll know exactly when the technician arrives through a live, trackable time.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Baytown
Our technicians train on nine opener brands, and the ones we see most often around Baytown are Linear, Viking, Ghost Controls, and DoorKing. We keep common parts for these in local stock, which trims turnaround on most repairs. See our brands for the full list.
Pricing for Gate Company in Baytown, TX
These are the ranges Baytown homeowners should expect before parts. Every quote is written, itemized, and agreed before work begins.
| Service | Typical range in Baytown |
|---|---|
| Gate opener repair (labor only) | $180 – $340 |
| Electric gate repair (labor only) | $200 – $400 |
| Full gate opener replacement | $750 – $1,900 |
| Service call / diagnostic fee | $69 |
| Limit switch replacement (the sensor that tells the gate when to stop) | $185 – $320 |
| Control board replacement | $225 – $385 |
| Safety edge / photo eye repair | $190 – $310 |
| Gate hinge replacement (per hinge) | $60 – $95 |
| Gate caster wheel replacement | $80 – $140 |
| Drive arm / actuator repair | $245 – $410 |
Prices in Baytown run toward the middle of these ranges most of the time. Rust-seized hardware and badly out-of-plumb posts push a job higher, and we’ll show you exactly why on the written quote before anything is ordered or installed. You approve the number first.
Neighborhoods We Serve in Baytown
We run service across Baytown daily, from the older streets off North Main to the newer builds west of Garth Road and the neighborhoods around Goose Creek, Bayway, and Lee Drive. Typical response for a gate repair call is same-day or next-morning, depending on when you call and what the gate is doing.
- Goose Creek area
- Lee Drive corridor
- Bayway Drive area
- Garth Road corridor (west side)
- North of I-10 near Baytown Nature Center
Service Area – Cities Near Baytown
Beyond Baytown, our crews take gate calls in the surrounding communities: La Porte, TX, Highlands, TX, Deer Park, TX, and Channelview, TX. You’ll get the same written price and the same 365-Day Done Right Promise in every one of them.
Serving Baytown, TX - Our Local Coverage Area
We’re based in the Baytown area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Baytown
Most Baytown repair calls get same-day or next-morning scheduling. The exact time depends on the failure and where the nearest technician is when you call. You’ll get a live, trackable arrival time, not a four-hour window. Call (903) 417-0793 to check today’s schedule.
For a repair on an existing residential gate, Baytown doesn’t require a permit, and you don’t need city approval. If your neighborhood HOA has a shared entry gate or architectural rules, check the quick requirement first – but most private driveway gate repairs move ahead same-day. We can note any HOA access requirements on your quote.
We serve all of Baytown plus La Porte, Highlands, Deer Park, and Channelview. If you’re within about 30 minutes of central Baytown, odds are we cover you. Call (903) 417-0793 with your cross streets and we’ll confirm a time on the spot.
If your gate is stuck, noisy, or dead, call Calder Gate Repair at (903) 417-0793 for a free estimate. A real person answers 24/7, we send a background-checked technician in uniform, and the price you’re quoted in writing is the price you pay. Nico Alvarez and the Calder team stand behind every repair with the 365-Day Done Right Promise.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Baytown Customers Say
"Booked online. The tech texted his ETA and arrived on time. Gate opener was dead; he replaced the control board and tested the sensors."
- Terry W."Booking was easy and the job was done quickly."
- Seth R."Swing gate arm replaced and aligned. Got photos of the old part by text."
- Nadia F.