Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Los Angeles Owner’s Guide

Ghost Controls keypad and intercom repair in Los Angeles typically runs $165 to $385 installed, depending on whether we’re replacing a wireless keypad, a wired intercom module, or the controller board that talks to your opener. Most jobs are finished in under 90 minutes, and we keep the most common Ghost Controls-compatible parts on the truck so you’re not waiting on a second visit. The way most Los Angeles homeowners discover a problem: the keypad lights up but the gate won’t move, or the intercom crackles and no amount of button-mashing gets a clean two-way conversation going.

Call (903) 417-0793

We’re Calder Gate Repair, and we work on Ghost Controls openers daily. This page covers what fails, what it costs, and what you can safely check before picking up the phone. And to be clear from the jump: we’re an independent repair company, not affiliated with Ghost Controls, but we repair and stock parts for their keypad and intercom systems across greater Los Angeles.

Key Takeaways

• Most Ghost Controls keypad and intercom repairs cost $165 to $385 installed in Los Angeles.
• We stock the common keypad, intercom, and antenna parts on the truck, so one visit is usually all it takes.
• You get a written price before any work starts, and the 365-Day Done Right Promise backs every repair.
• Call (903) 417-0793 for a free estimate. A live person answers 24/7, not a voicemail tree.

Which Ghost Controls Models This Applies To

Ghost Controls makes a fairly tight lineup of opener systems, but the keypads and intercoms cross several model families. The WKP1 wireless keypad works with the AXDP, HDP1, and AXP series that Ghost Controls has sold over the last decade and change. The intercom side gets trickier: older systems used a two-wire analog intercom, while the newer Ghost Controls kits lean on wireless keypad plus a separate call box module. If you still have the manual, the model sticker is usually inside the battery compartment of the keypad or on the back of the intercom faceplate.

Here’s the compatibility gotcha we see in Los Angeles all the time: a Ghost Controls system from 2015 might still have the gray keypad housing, but the receiver board was updated around 2018, and the older keypad won’t pair cleanly with a newer control board without a frequency mismatch. Swapping the keypad alone sometimes makes the problem worse if the real issue is an aging receiver on the opener side. Nico Alvarez, our owner and lead technician, has diagnosed this exact failure pattern enough times in LA to check the receiver first when a Ghost Controls keypad goes intermittent.

We carry OEM Ghost Controls parts and a quality aftermarket line we’ve tested extensively. The OEM units run pricier, but they pair without drama. The aftermarket keypads we stock are waterproofed to match LA’s marine layer and work fine on the AXDP and HDP1 lines. For intercoms, we lean OEM almost always. The aftermarket intercom boards just don’t hold up to direct sun exposure on a west-facing gate in the Valley.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• Keypad lights up but the gate does nothing. This usually means the receiver board on the opener side has failed or lost its programming, not that the keypad itself is dead. The keypad sending a signal and the board ignoring it are two different problems, and replacing the keypad won’t fix the second one.
• Keypad needs a second press every time. A worn keypad membrane or a dying battery can cause this, but more commonly in LA, the issue is the rubber dome contacts oxidizing from the salty air near the coast. We see it most in Santa Monica, El Segundo, and Venice Beach homes.
• Intercom buzzes and the voice cuts out. This is almost always the speaker cone degrading or a short in the wiring between the call box and the house handset. If you hear a steady hum with no voice, the amplifier circuit on the intercom board is likely cooked.
• Keypad works one day and not the next. Intermittent behavior points to a failing antenna connection or a cold solder joint on the receiver board. Heat expanding and contracting the board in Desert LA neighborhoods like Lancaster or Palmdale makes this worse.
• The gate works from the remote but not the keypad. That’s a clean signal that the keypad transmitter is the problem, not the opener. This is actually the best-case scenario for a straightforward swap.

Replacement Cost & What’s Included

In Los Angeles, a Ghost Controls wireless keypad replacement runs $165 to $245 installed. A wired intercom replacement ranges $225 to $385 depending on whether we’re pulling new low-voltage wire. If the receiver board on the opener needs to be replaced at the same time, that adds about $110 to $160 for the part.

Every quote follows the same rule: the price you agree to before we start is the price on the invoice. No surprises at the door. The written quote includes the part, the labor, removal of the old unit, programming the new one to your opener, and testing the full cycle from both the keypad and any remotes. After the job, we email a digital invoice with before-and-after photos, and you pay from a link, no paper shuffling needed.

The repair also carries the 365-Day Done Right Promise. If the keypad or intercom fails within 365 days, Calder Gate Repair returns at no charge. That’s in writing on every ticket, no fine print.

DIY or Call Us?

You can safely check a few things without tools: replace the keypad battery, wipe down corroded battery terminals, and check that the intercom handset isn’t unplugged. Those fixes work maybe one time in five. Anything that involves opening the keypad housing, touching the low voltage wiring, or reaching the control board on the opener side is where we’d ask you to stop. Low voltage doesn’t sound dangerous, and it usually isn’t, but a misplaced wire can short the board and turn a $200 keypad job into a $500 board replacement.

Our technicians are background-checked, uniformed, and dispatched with a live arrival time you can track, not a four-hour window. We show up when we say we will, diagnose the Ghost Controls part in front of you, and write the price before we touch a screwdriver. Call (903) 417-0793 and a real person answers, day or night.

FAQs