Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Inglewood, CA
Gate repair in Inglewood means dealing with a specific mix of older wrought-iron driveway gates, newer aluminum estate gates, and a whole lot of electric openers that have been run hard for years. If your gate won’t open, sags on its hinges, or makes a grinding sound when the opener kicks in, you’re in the right place. Calder Gate Repair is the dedicated gate service company serving Inglewood, CA, and we’re the team homeowners call when they want a written price before any work starts and a repair that actually holds up. Our phone line is answered by a live person 24/7 at (903) 417-0793.
Why Inglewood Homes Are Different
Inglewood’s housing stock leans heavily toward single-family homes built between the 1940s and 1970s, and a lot of those properties still carry their original driveway gates. That matters because older steel and wrought iron doesn’t fail the way newer aluminum does. We see rust creeping through welded joints, hinge posts that have shifted slightly out of level after decades of settling, and gate frames that have been welded once or twice already by previous owners. Every Inglewood service call starts with a close look at how the gate itself is mounted before we even touch the opener.
The coastal-influenced climate also has a say. Inglewood sits close enough to the ocean that morning marine layer settles in regularly, especially through late spring and early summer. That moisture seeps into gate frames and control boxes. We regularly find corroded circuit boards and limit switches – the small sensors that tell the gate when to stop – in Inglewood gates that look fine on the outside. Homes near Morningside Park and the streets off Centinela Avenue tend to show this corrosion more than homes up toward the Hollywood Park area, where newer construction and fresh gates are more common.
Our Main Inglewood Services
Most Inglewood calls fall into three buckets: a gate that won’t move, an electric system that’s acting erratically, or an opener that runs but doesn’t do what it should. Each has its own dedicated page below.
Gate Repair in Inglewood
A sagging or stuck gate in Inglewood usually comes down to hinges, weld fatigue, or a post that’s drifted. On older wrought-iron gates, we often find the hinge side has been taking more weight than it should for years. Calder Gate Repair does full mechanical Gate Repair in Inglewood work, from re-hanging and re-welding to replacing damaged pickets and re-leveling the frame. We write the price down before we unbolt anything, and every repair carries the 365-Day Done Right Promise in writing.
Electric Gate Repair in Inglewood
Electric gates fail in predictable ways here. Photo-eye sensors get knocked out of alignment. Wiring in older conduits gets brittle. Control boards take on moisture from that morning marine layer. Our electric gate work in Inglewood covers the full low-voltage and line-voltage side of the system. If your gate opens but won’t close, or trips its breaker repeatedly, that’s a wiring or board issue we can diagnose on site. See Electric Gate Repair in Inglewood for exactly how we handle these calls.
Gate Opener Repair in Inglewood
Openers on Inglewood gates run hot and get cycled constantly, especially on driveways used by more than one car. The opener’s limit sensors, capacitor, and drive belt or chain take the most abuse. We handle Gate Opener Repair in Inglewood across FAAC, LiftMaster, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule units. When the opener hums but the gate doesn’t move, or the remote works only from ten feet away, we trace it to the component level rather than just swapping the whole box.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Inglewood
Inglewood gates run on a mix of opener brands depending on when the gate was installed. We are factory-familiar with FAAC, BFT, Linear, Viking, LiftMaster, Ghost Controls, DoorKing, Elite, and Mighty Mule. Our techs carry common parts and boards for these brands in the van, which means many Inglewood opener repairs get done in one visit. See our brands for the full breakdown.
Pricing for Gate Company in Inglewood, CA
| Service | Typical range in Inglewood |
|---|---|
| Gate opener repair (labor only) | $180 – $340 |
| Gate opener motor replacement | $450 – $850 |
| Opener circuit board replacement | $250 – $450 |
| Limit switch replacement | $120 – $220 |
| Hinge replacement (pair of heavy-duty hinges) | $150 – $350 |
| Gate frame re-welding or reinforcement | $200 – $500 |
| Photo-eye sensor realignment or replacement | $100 – $200 |
| Remote or keypad reprogramming | $75 – $150 |
| Full service call and diagnostic | $79 – $129 |
| New gate opener installation (opener + labor) | $1,100 – $2,400 |
Two things push Inglewood prices toward the upper end of these ranges: heavy steel gates that need additional labor to re-hang, and opener failures that involve both a board and a mechanical component. Every job gets a written price before work starts, and the number on the invoice is the number you agreed to, never a surprise.
Neighborhoods We Serve in Inglewood
Calder Gate Repair covers all of Inglewood, and our local techs know the gate styles you’ll find block by block. Response time across Inglewood is typically same-day for urgent repair calls, with live arrival tracking from dispatch.
- Morningside Park
- Hollywood Park
- Downtown Inglewood
- North Inglewood
- Century Heights
Service Area – Cities Near Inglewood
If your gate sits just outside the Inglewood city line, Calder still covers you. We take repair calls in Hawthorne, CA, Culver City, CA, El Segundo, CA, and Lawndale, CA. Pricing stays flat across the service area – no hidden travel charges.
Serving Inglewood, CA - Our Local Coverage Area
We’re based in the Inglewood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Inglewood
We offer same-day response for most Inglewood repair calls, especially if the gate is stuck open or won’t close. When you call the 24/7 line, a live person books the appointment and gives you a trackable arrival time, not a four-hour window.
Most repairs – hinges, openers, boards, sensors – need no permit in Inglewood. Full new gate installations sometimes fall under city fencing and height rules. We’ll tell you on site if your job scope triggers anything, before we quote the work.
Yes. We regularly work inside Inglewood communities with HOA-managed gates. If your HOA needs a written quote or a certificate of insurance before work proceeds, we can provide that same day. The quote comes in writing, and the HOA can review it before any repair begins.
If your Inglewood gate is giving you trouble, call Calder Gate Repair at (903) 417-0793 for a free estimate. A live person answers, the price is in writing before work starts, and every repair is backed by the 365-Day Done Right Promise.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Inglewood Customers Say
"Safety sensors realigned. Works fine. Photo eyes were dirty and out of line. Gate now stops when it should."
- Raul A."Booked online. The tech texted his ETA and arrived on time. Gate opener was dead; he replaced the control board and tested the sensors."
- Terry W."Booking was easy and the job was done quickly."
- Seth R.