Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in West Hollywood, CA
Calder Gate Repair is the gate company West Hollywood homeowners call when a driveway gate stops responding, slides off track, or starts grinding loud enough that neighbors two doors down can hear it. Most gate repairs in West Hollywood run $160 – $380 before parts, and we quote every job in writing before touching a bolt. We’re the gate division of Relay Home Co., founded in 2009, with crews serving West Hollywood from the brand’s Los Angeles office. Call (903) 417-0793 anytime, day or night, and a live person answers.
Why West Hollywood Homes Are Different
West Hollywood’s housing is dense. Condo buildings, hillside duplexes, bungalow courts, and a handful of private single-family lots all sit close together, which means gate noise is everyone’s problem and gate access is a daily negotiation with neighbors, HOAs, and street parking. The coastal-influenced air carries moisture and the Santa Monica-adjacent marine layer pushes in often. Exposed gate hardware rusts faster here than it does in the Valley, and we see it in every neighborhood: oxidized hinge brackets, corroded limit switch terminals, opener circuit boards that fail from condensation even though the gate has never been rained on while open.
Hillside properties along the streets climbing up from Santa Monica Boulevard face a second issue: slope. A gate on a 6-degree pitch puts constant lateral load on the hinge welds and the slide track in a way flat lots never do. We routinely re-square leaning gates in West Hollywood and rebuild track mounts anchored in aging stucco or old brick pillars that predate current code. If your building is in an HOA, the association often owns the gate and needs a written proposal before approving work. We supply that, with the price in writing so the board knows the number the day you call, not after a first visit.
Our Main West Hollywood Services
Most West Hollywood calls fall into two buckets: the gate itself is physically broken, or the opener that moves it has failed. Both are covered below, each with its own dedicated West Hollywood page.
Gate Repair in West Hollywood
This is the mechanical side: a swing gate that drags on the concrete, a slide gate that wobbles off its rail, a hinge weld that cracked and left the whole panel hanging at a six-degree tilt. In West Hollywood, we see more rusted hinge bosses and bent track brackets than anything else, mostly because the coastal air keeps eating exposed steel. Crews arrive with the common bracket sizes, roller assemblies, and hinge kits already on the truck, so most jobs wrap in one visit. Read the full service breakdown on our Gate Repair in West Hollywood page.
Electric Gate Repair in West Hollywood
Electric gates include everything powered: safety sensors, photo eyes, keypads, intercom panels, and the low-voltage wiring feeding all of it. West Hollywood condos and apartment buildings lean heavily on keypad and intercom access, and a dead controller at 7 a.m. can trap a whole building. We diagnose control boards, replace corroded terminal blocks, and re-run damaged wiring where gates have been nudged by delivery trucks or clipped by waste bins on narrow streets. Details are on the Electric Gate Repair in West Hollywood page.
Gate Opener Repair in West Hollywood
The opener is the motor and gearbox that actually moves the gate. When it hums but doesn’t move, or slams instead of slowing, the problem is usually the opener itself: worn gears, a failed capacitor, a limit switch that lost its setting, or a control board that stopped reading the remote. We work on the openers West Hollywood homeowners actually own, including Viking, Ghost Controls, and DoorKing among others. Most opener repairs run $190 – $380 before parts. See Gate Opener Repair in West Hollywood for the full scope.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in West Hollywood
Our technicians are factory-familiar with nine opener brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. We carry common logic boards, remote receivers, and safety-edge parts for these units on service trucks, which means many West Hollywood repairs finish the same afternoon. See our brands for the full compatibility list.
Pricing for Gate Company in West Hollywood, CA
| Service | Typical range in West Hollywood |
|---|---|
| Gate repair service call | $95 – $135 |
| Gate track repair | $180 – $320 |
| Hinge replacement (per pair) | $140 – $250 |
| Gate opener motor replacement | $350 – $700 |
| Gate opener circuit board replacement | $250 – $450 |
| Remote or keypad programming | $85 – $150 |
| Safety sensor replacement | $120 – $220 |
| Electric strike or lock replacement | $180 – $320 |
| Full gate opener replacement (parts and labor) | $850 – $1,900 |
Two things push prices up in West Hollywood specifically: hillside loads on hinges and tracks, and HOA requirements for written proposals or specific parts. Whatever the number is, we put it in writing before any work starts and the invoice matches it to the dollar.
Neighborhoods We Serve in West Hollywood
We cover all of West Hollywood, from the streets off Sunset Boulevard to the residential blocks along Santa Monica Boulevard and up into the hills. Door-to-door response is usually under 90 minutes for most of the city.
- Norma Triangle
- West Hollywood West
- Tri-West
- The Avenues
- Kings Road
Service Area – Cities Near West Hollywood
Calder Gate Repair also serves homeowners in the cities surrounding West Hollywood. If you’re just outside the city line, we likely cover you too. See our pages for Beverly Hills, CA, Culver City, CA, Glendale, CA, and Burbank, CA.
Serving West Hollywood, CA - Our Local Coverage Area
We’re based in the West Hollywood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in West Hollywood
Most West Hollywood addresses get a technician in under 90 minutes, because we dispatch from the Los Angeles office and keep crews routed near the city throughout the day. Emergency calls after hours are answered by a live person who can book on the spot.
If the HOA owns the gate or it sits on common property, yes, and we’ll give you a written quote you can forward to the board. If the gate is on your private lot and not in the CC&Rs, you can typically approve the work yourself.
We cover the entire city of West Hollywood, including hillside streets and condo complexes with tight entry access. If you’re near the Beverly Hills or Culver City line, call and we’ll confirm coverage before dispatch. That call is free, and so is the estimate.
Call Calder Gate Repair at (903) 417-0793 for a free estimate on any gate problem in West Hollywood. A live person answers 24/7, and every repair comes with the 365-Day Done Right Promise: if the fix fails within a year, we return at no charge.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What West Hollywood Customers Say
"Good job on the motor. Part took a few days to arrive, but the updates came by text."
- Oscar J."Safety sensors realigned. Works fine. Photo eyes were dirty and out of line. Gate now stops when it should."
- Raul A."Booked online. The tech texted his ETA and arrived on time. Gate opener was dead; he replaced the control board and tested the sensors."
- Terry W.