Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Plantation, FL
When a gate stops opening in Plantation, you’re usually dealing with one of three things: a failed opener motor, a broken hinge or weld, or a limit switch that’s lost its position. Most repairs run between $180 and $470 before specialty parts, and our technicians keep the common LiftMaster, FAAC, and Linear components on the truck. Calder Gate Repair handles the whole job from diagnosis to tested finish, with a written price before anything gets touched. Call (903) 417-0793 if your gate is stuck right now.
Why Plantation Homes Are Different
Plantation’s housing stock runs older and greener than most of Broward County. Streets like those off Broward Boulevard and near Plantation Acres were built with larger lots and mature landscaping, which means longer driveway runs, heavier custom gates, and opener systems that work harder than they would on a zero-lot-line property. We regularly see gates in the Jacaranda Lakes and Fountain Springs areas where tree roots have shifted the concrete pad under the gate post, throwing the hinges out of alignment.
The humidity here is the silent variable. Salt-damp air shortens the life of circuit boards and corrodes limit-switch contacts faster than inland installations. We also run into a lot of HOAs in Plantation that have specific rules about gate height, finish, and opener noise, so we’ll flag those early if your community has restrictions. None of this is exotic to us, but it does mean the repair route changes block by block.
Our Main Plantation Services
Most Plantation homeowners call us for one of two reasons: a gate that won’t move, or a gate that moves but won’t stop safely. Each service has its own page here with pricing and the step-by-step of the job.
Gate Repair in Plantation
This covers the mechanical side: bent or rusted hinges, sagging weld points, latch problems, and gates that scrape the ground because a post has shifted. In Plantation we see a lot of steel tube gates with rust at the bottom rail where irrigation overspray hits daily. We cut out the bad section, weld in new steel, and realign the post instead of slapping on a hinge shim and calling it done. Gate Repair in Plantation
Electric Gate Repair in Plantation
Electric gate work is anything involving the motor, power supply, safety loops, or control board. Plantation’s frequent afternoon storms send voltage spikes that take out capacitors and transformer leads, so we test the whole circuit path rather than just swapping the part that looks burnt. A proper electric fix includes checking the force settings and the photo-eye alignment so the gate stops and reverses the way it should. Electric Gate Repair in Plantation
Gate Opener Repair in Plantation
Gate opener repair zeroes in on the unit that actually moves the gate: the arm, the gearbox, the remote receiver, and the programming. In Plantation we see plenty of openers that die young because they were undersized for a solid-iron gate. We’ll confirm the opener’s duty rating matches the gate, then repair the motor or board and reprogram remotes and keypads in one visit, not two. Gate Opener Repair in Plantation
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Plantation
Most Plantation gates run on one of four brands: FAAC, BFT, Linear, or Viking. We stock their common boards, arms, remotes, and capacitors on the truck, which means we can often finish the job in one trip. If the part isn’t in inventory, we order from our brands network and schedule the return visit before we leave.
Pricing for Gate Company in Plantation, FL
| Service | Typical range in Plantation |
|---|---|
| Gate opener diagnostic & minor repair | $95 – $180 |
| Gate opener circuit board replacement | $250 – $475 |
| Gate opener motor replacement | $350 – $650 |
| Gate opener arm replacement | $275 – $500 |
| Hinge replacement (welded or bolted) | $180 – $380 |
| Post realignment or concrete shim | $250 – $500 |
| Limit switch replacement | $120 – $225 |
| Remote receiver or keypad repair | $125 – $275 |
| Safety loop or photo-eye replacement | $185 – $320 |
| Emergency gate unstuck / disconnect | $150 – $350 |
Plantation pricing gets pushed up when a gate is custom-built around a non-standard post or when the opener is old enough that replacement parts are special-order rather than stocked. But you’ll know the number before we start: the written quote is agreed at the door, and the invoice matches it.
Neighborhoods We Serve in Plantation
We cover the full city, including the older sections near Plantation Golf Course and the larger lots out toward Plantation Acres. Most areas in Plantation see us within one to two hours of the call.
- Jacaranda Lakes
- Fountain Springs
- Plantation Acres
- Central Plantation
- Plantation Isles
Service Area – Cities Near Plantation
We also run calls into the surrounding Broward cities. If your gate is in Fort Lauderdale, FL, Margate, FL, Coconut Creek, FL, or Pompano Beach, FL, the same crew that knows Plantation’s gates can reach you. Dispatch and scheduling run from the brand’s Miami-area office, but technicians serve Plantation locally with the same written-price promise.
Serving Plantation, FL - Our Local Coverage Area
We’re based in the Plantation area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Plantation
Most Plantation neighborhoods get a technician within one to two hours. Emergency calls are answered by a live person 24/7, and you’ll get a trackable arrival time from the moment the job is booked. No four-hour windows here.
If your community has a gate standard, we’ll work from whatever the HOA requires. We’ll flag any obvious restriction during the estimate so you don’t get a letter down the road. The repair itself rarely needs a permit, but we’ll tell you if yours does.
Yes. Every job gets a written price before work starts, and the invoice matches that number unless you approve a change in writing. That’s a standing rule at Calder, not a promotion.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Plantation Customers Say
"Booking was easy and the job was done quickly."
- Seth R."Swing gate arm replaced and aligned. Got photos of the old part by text."
- Nadia F."Quote came in the app before the visit. No surprise at the end."
- Ginny L.