Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Alamo Heights, TX
Calder Gate Repair is the gate company Alamo Heights homeowners call when a driveway gate won’t open, a keypad stops responding, or an electric opener starts grinding. We’re part of the Relay Home Co. family, founded in 2009, and every technician arrives in uniform with a written price in hand before any work begins. Homes here sit on compact lots with tight driveway clearances and mature trees, which means gate work often involves working around stone columns, iron fencing, and older hardware that’s been in place for decades. Call (903) 417-0793 and you’ll reach a live person, day or night.
Why Alamo Heights Homes Are Different
Alamo Heights is one of the densest, most established pockets of San Antonio. The housing stock runs older than most of the surrounding metro; many properties predate the 1960s, and the driveways reflect that. Gates here are frequently set between limestone or brick columns, sometimes on slopes, and often paired with wrought-iron fencing that has settled over the years. That settlement matters: a gate that once swung cleanly can start dragging on the catch post or binding at the hinge side after a few seasons of clay soil expansion and contraction.
The climate compounds it. Summer heat bakes the control boards and capacitors inside opener cabinets, while the spring and fall storms bring enough moisture to corrode terminals and wiring connectors that sit exposed at the hinge side of the gate. We regularly see Alamo Heights gate failures tied to sunlight-cooked circuit boards in July and August, and limit switch failures – the small sensors that tell the gate when to stop – after wet weather. Homes near Broadway and along the side streets off Nacogdoches Road tend to have gates closer to the street, so noise and curb appeal matter to the owners. The work here is rarely a simple swap; it’s solving for tight clearances, older panels, and gates that were installed before modern safety edges became code.
Our Main Alamo Heights Services
The two calls we hear most from Alamo Heights homeowners are a gate that won’t move at all and an opener that runs but won’t shift the gate leaf. Each has its own page below because the diagnosis, parts, and pricing differ enough to matter.
Gate Repair in Alamo Heights
Gate repair here usually means mechanical work: hinge replacements, sagging gate leaves, bent track sections, latch and lock hardware, or a gate knocked out of alignment by a storm or a stray vehicle bump. On older Alamo Heights properties we often find original iron gates that have simply worn past the point of adjustment; the fix is a new hinge set or realignment, not a full replacement. We’ll tell you if the gate can be repaired rather than replaced, because on a property with a limestone column and mature landscaping, keeping the original iron is usually the better call. Full details on Gate Repair in Alamo Heights.
Electric Gate Repair in Alamo Heights
Electric gate repair covers the powered side of the system: motors that hum but don’t move, wiring that has failed at the underground junction, sensors that cause the gate to reverse mid-cycle, and keypads or intercom systems that don’t release the gate. In Alamo Heights, we see a lot of underground wiring runs from driveway gates to the house, and digging down to a failed splice is sometimes the quickest fix once the fault is isolated. Safety edges – the strips that stop the gate if something is in the way – are the other common call. Electric Gate Repair in Alamo Heights has the specifics.
Gate Opener Repair in Alamo Heights
When the mechanical gate moves fine by hand but won’t budge when you press the remote, the opener is the suspect. We diagnose swing-arm and slide operators, replace burned-out capacitors, reprogram remotes and keypads, and swap tired circuit boards before they fail completely. Alamo Heights homes with older opener units often have boards that are no longer made, and we stock or source replacements for the major brands so you aren’t stuck waiting weeks. The full breakdown is on Gate Opener Repair in Alamo Heights.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Alamo Heights
Our technicians are factory-familiar with Linear, Viking, Ghost Controls, and DoorKing, among others, and we stock the most common replacement boards, remotes, and safety parts on our trucks. That means most Alamo Heights opener repairs are finished same day. See the full list on our brands page.
Pricing for Gate Company in Alamo Heights, TX
What does gate work actually cost in Alamo Heights? The table below reflects what we quote most often in this part of San Antonio. Older homes with non-standard mounts and tight access can push a job to the upper end, but every price is written down and agreed to before we touch a bolt.
| Service | Typical range in Alamo Heights |
|---|---|
| Gate opener motor replacement | $450 – $1,200 |
| Gate opener circuit board replacement | $250 – $550 |
| Limit switch repair | $150 – $300 |
| Remote transmitter programming or replacement | $75 – $180 |
| Keypad replacement | $120 – $280 |
| Hinge replacement (set of 2) | $180 – $400 |
| Gate realignment | $150 – $350 |
| Track or wheel replacement (slide gates) | $200 – $450 |
| Safety edge replacement | $250 – $500 |
| Diagnostic service call | $85 – $125 |
What pushes a quote up in Alamo Heights is usually access: gates set back behind mature landscaping or built into a stone column take more time to work on safely. What doesn’t change is the number on the page. That number is the number you pay, every time, because a written price before work starts is never optional with Calder Gate Repair.
Neighborhoods We Serve in Alamo Heights
We work across Alamo Heights and the surrounding pockets, including the streets off Broadway, the residential blocks east of Nacogdoches Road, and the numbered streets near the high school. Response for a service call in Alamo Heights is typically same-day when booked before early afternoon, and emergency calls are dispatched within the hour when a live tech is available.
- Streets off Broadway near the shops and restaurant strip
- Residential blocks east of Nacogdoches Road
- Numbered streets surrounding Alamo Heights High School
- Homes along the northern edge near the quarry and golf course
- Side streets between Austin Highway and the Olmos Basin
Service Area – Cities Near Alamo Heights
Calder Gate Repair dispatches locally to Alamo Heights and the surrounding metro. We also serve homeowners across the wider region, including Houston, TX, San Antonio, FL, Dallas, TX, and Fort Worth, TX, with the same written-price standard on every job.
Serving Alamo Heights, TX - Our Local Coverage Area
We’re based in the Alamo Heights area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Alamo Heights
Same-day service is typical when you call before early afternoon. Emergency calls – a gate stuck open or a failed safety edge – are dispatched as quickly as the next available tech can reach you. Call (903) 417-0793 and a live person will give you a real arrival time, not a window.
Most repair work on an existing gate – hinge swaps, board replacement, opener repair – does not require a permit. If your HOA has design standards, a repair that keeps the gate looking the same is almost always fine. New gate builds get reviewed on a case-by-case basis, and we’ll let you know what your specific Alamo Heights neighborhood requires.
Yes. A diagnostic call runs $85 to $125 in Alamo Heights, and if you proceed with the repair that same visit, the diagnostic fee is applied toward the total. You’ll get the written repair price before anything is done, and the 365-Day Done Right Promise covers every repair we complete. Call (903) 417-0793 for a free estimate.
If your gate is acting up in Alamo Heights, TX, call Calder Gate Repair at (903) 417-0793. A real person answers, you’ll get a live arrival time from a background-checked technician, and the price is written down before any work starts. That’s how we work, every time.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Alamo Heights Customers Say
"Booked online. The tech texted his ETA and arrived on time. Gate opener was dead; he replaced the control board and tested the sensors."
- Terry W."Booking was easy and the job was done quickly."
- Seth R."Swing gate arm replaced and aligned. Got photos of the old part by text."
- Nadia F.