Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGhost Controls Gate Repair in Manhattan, CA | Calder Gate Repair
Ghost Controls gate repair in Manhattan runs $180 – $340 for most board, limit switch, and battery fixes, and we complete most jobs the same day we arrive. What makes Ghost Controls work here different is the coastal fog belt: operators on Manhattan’s west side corrode two to three years faster than identical units just a few miles inland, and we diagnose with that in mind from the first symptom. We’re Calder Gate Repair, an independent Brooklyn Ghost Controls service provider serving Manhattan and the surrounding beach cities. Call (903) 417-0793 for a free estimate.
Why Manhattan Residents Choose Us for Ghost Controls Service
We’ve serviced hundreds of Ghost Controls solar and low-voltage operators across Manhattan, from TSS1 single swing arms on walk gates to AXLE slide operators on driveways. As an independent shop, we diagnose by symptom and repair the actual failure. We don’t swap boxes hoping the problem goes away.
Nico Alvarez, our owner and lead technician, has spent the better part of two decades working gate repair across Los Angeles County. He started Calder Gate Repair because he was tired of homeowners getting vague estimates and surprise charges. That’s why every Manhattan job gets a written price before any work begins, and every repair carries our 365-Day Done Right Promise: if it fails within a year, we return at no charge.
We stock genuine Ghost Controls replacement boards, motors, and limit switches, and we use high-quality aftermarket batteries and solar panels where they outperform OEM at lower cost. When you call, a live person answers 24/7, and you get a trackable arrival time, not a four-hour window.
Common Ghost Controls Gate Repair Problems We Solve in Manhattan
- Solar charge controllers failing from salt air and winter freeze-thaw cycles. Manhattan’s coastal fog deposits a fine layer of salt on solar panels and control boxes. Over time, the charge controller corrodes, batteries stop charging fully, and the gate dies midwinter. We test the controller’s output, clean or replace panels, and reseal the board enclosure.
- Limit switches drifting on older swing arms after years of wind loading off the Hudson. Wind off the Hudson pushes hard against Manhattan gates, especially on west-facing lots. On Ghost Controls TDS2 and TSS1 arms, the limit switch bracket can shift or corrode, causing the gate to slam or reverse mid-travel. We replace these with stainless Ghost Controls limit switches and re-calibrate travel.
- Control boards corroding from coastal humidity and road-salt splash. Phantom open/close commands are a telltale sign of a corroded board. Keypad codes stop registering, or the gate opens on its own. We inspect the board for moisture damage, clean contacts when salvageable, and install a genuine Ghost Controls board when it isn’t.
- Battery backup packs swelling and losing capacity on solar-only setups. Manhattan’s fog means solar panels deliver less consistent charge than homeowners expect. Batteries deep-discharge repeatedly, then swell or fail. We size replacement batteries to actual panel output and shade conditions on your property, not just the factory spec.
- Solar panel films clouded by salt and moisture, starving the system. A Ghost Controls solar setup in Manhattan needs panel cleaning more often than an inland install. We include panel cleaning and connection sealing as part of our routine service calls, and we’ll tell you the real replacement interval for your specific location.
Ghost Controls Service in Manhattan: What Local Conditions Mean for Your Equipment
Manhattan’s coastal fog belt and salt-laden air accelerate corrosion on solar panels and exposed control boxes far faster than inland LA. We see gate operators on the west side fail from corrosion two to three years earlier than the same units installed just a few miles inland toward downtown Los Angeles. For a Ghost Controls owner in Manhattan, that means the standard maintenance calendar doesn’t apply to you, unlike Ghost Controls in Long Beach. A solar panel that would last five years in El Segundo might need replacement in three here. A control board that would stay clean in Torrance could show corrosion within eighteen months on a Manhattan lot within half a mile of the beach. The repair priority shifts accordingly: we encapsulate boards proactively, add drip loops to solar cables, and recommend panel cleaning on a schedule matched to your block’s fog exposure. Tell me what it’s doing, and I’ll tell you what it’ll cost, before I touch anything.
Ghost Controls Models & Products We Service in Manhattan
We service the full Ghost Controls lineup you’re likely to own in Manhattan: the Heavy-Duty Dual (HD2) solar gate opener kits, TSS1 single swing gate openers, TDS2 dual swing gate openers, and the AXLE Series (AXS) slide gate operators. We also work on Ghost Controls keypads, vehicle sensors, and the battery backup attachments. For boards, motors, and limit switches, we stock genuine Ghost Controls parts. For batteries and solar panels, we use high-quality aftermarket options where they outperform OEM at lower cost, which is often the case in Manhattan’s coastal conditions. If your operator is over 8 – 10 years old and has both a dead board and a worn gearbox, we’ll tell you straight whether a rebuild or a new unit makes more sense. We won’t sell you a rebuild that’ll last six months.
Ghost Controls Service Pricing in Manhattan
Most Ghost Controls gate opener repairs in Manhattan run $180 – $340 before parts, depending on the failure. Limit switch replacement and travel calibration sits at the lower end. Control board replacement lands in the middle. Solar charge controller and battery replacement together can reach the higher end. Parts are quoted separately, and you’ll see the full written price before any work starts, not after. When we diagnose, we show you exactly what failed, what the part costs, and what labor is involved. No invoice surprises, ever.
Every estimate covers the service call, diagnosis, and written quote. Call (903) 417-0793 to book yours. We’ll tell you the likely range over the phone before we even dispatch.
Serving Manhattan, NY - Our Local Coverage Area
We’re based in the Manhattan area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs – Ghost Controls Gate Repair in Manhattan
The usual cause is a solar charge controller that’s either corroded or unable to push enough charge to the battery after several days of low sun and salt film on the panel. We start by cleaning the panel, testing controller output, and load-testing the battery. Call (903) 417-0793 for a free estimate.
Yes, you can replace just the control board on a TSS1. The board is a separate, replaceable component, and we stock genuine Ghost Controls boards for same-day repairs in Manhattan. Replacing a whole operator is only worth considering if the board is dead and the gearbox or motor is also worn, usually on units over 8 – 10 years old. We’ll show you the condition of each component before recommending either path.
Yes. Ghost Controls operators support add-on receivers for phone app control and wireless keypads, and we install both across Manhattan. We also service the keypads themselves, which can corrode faster in coastal air. Smart Access is a standard part of our Ghost Controls repair in Staten Island and Manhattan.
Every 2 – 3 months on most Manhattan lots, and more often if you’re within half a mile of the beach or have trees overhead. Salt film from the fog is the main culprit, and it cuts panel output faster than most owners realize. We include cleaning on service calls and can set you up with a reminder cadence that matches your block.
Yes. We’re factory-familiar with nine major brands, including LiftMaster, FAAC, BFT, Linear, Viking, DoorKing, Elite, and Mighty Mule, so we can service or replace your gate opener regardless of what’s currently installed. If your Ghost Controls unit is beyond saving, we’ll quote a new operator from the brand that fits your gate and budget, and we’ll give you the written price before you commit.
Service Areas Near Manhattan
We service Ghost Controls gates across Manhattan and the surrounding beach cities. Our Manhattan service area covers the full city and nearby neighborhoods. We also regularly work in Los Angeles, Brooklyn, Queens, and Houston, and we offer Ghost Controls sales & service throughout the region. For owners further out, we also run Ghost Controls service in San Antonio and Ghost Controls service in San Diego.
Book Your Ghost Controls Service in Manhattan Today
If your Ghost Controls gate is acting up in Manhattan, call Manhattan Gate Repair at (903) 417-0793. We’ll diagnose it over the phone, give you a real arrival time, and put the price in writing before any work starts. Same-day service is available for most repairs.
Written by Nico Alvarez, Owner at Calder Gate Repair, serving Manhattan since 2009.